50 Series Airport Snow Plows

Frink America's polymer Airport 50 Series snow plows are the leader in airport equipment for snow removal.  The polymer moldboard is lighter than aluminum and stronger than steel.  Snow will not stick to it at any temperature.

Frink America snow plows are recognized by authorities as the standard of the industry and are backed by over 65 years of experience devoted exclusively to the design and manufacturing of quality snow plows for your airport equipment needs.

Reverse-A-Cast

• Exclusive flexible moldboard changes shape and positions for maximum versatility.

• Adjusts from 33" to 51" high.  Also reverses position.

• Uses our ram reverse or worm gear drive frames.

• Performance proven features include fuel saving polymer moldboard and trip edge design.

Roll Over Snow Plow

Features:

• Heavy duty construction.
• Panel type moldboard increases rigidity and strength.
• The increased taper of the plow provides extra width at the discharge making it effective in spreading the snow.
• Two reversible cutting edges.
• Standard equipment includes: 10 GA. moldboard, (2) reversible cutting edges, (3) moldboard shoes per edge, cone and housing assembly, drive bar and steady braces

Features:

• Rotation of the moldboard may be done while the chassis is in motion or in a stationary position.

• The roll over plow can make parking easier by being held in the upright position still attached within the chassis' own width.

• Rotation achieved through a planetary gear system utilizing two hydraulic cylinders.

• Optional equipment: Carbide moldboard shoes, 10" steel caster assemblies, 3/4" x 6" carbide cutting edges and 2" x 12" polymer cutting edge.

Roll Over Hitch

Features:

• Intended for a truck chassis with more then 35,000 pound GVWR and also to be used in conjunction with a roll over plow.

• Heavy duty construction.

• Close fit to front of chassis.

• 30.5" plow pinning centers.

• 1/2" cheekplate kit (cheekplates not shown in image).

• Allows for three pinning heights.

• Can be set up and used with a Frink America wing system and wing.

• Uses a 4" bore by 16" stroke cylinder with two single 7" diameter sheaves attached to both ends of the cylinder to raise and lower the plow during travel position and during roll over phase.

• 5/8" diameter 8x19 I.P.S. wire rope.