Trip moldboard design with 10 gauge break formed skinplate 36” high at center tapering upwards to 54” (56” on 12’ length) at the discharge end.

Moldboard reverses 35 degrees either side of the bull dose position.

Two 3-1/2” diameter bore by 16” stroke reverse cylinders.

Two point level lift chain arrangement or roller level lift arrangement available.

Oscillator bar with 1” flame cut ears on 31” centers.

Ram reverse or worm gear reverse options.

1/2” by 8” C-1085 cutting edge.

Cutting edge backer angle shall be punched on 8” and 12” centers.

Moldboard and curb shoes supplied standard.

Optional carbide blades and carbide moldboard shoes.

Optional mushroom shoes or 10” steel wheel caster assemblies available.

RL Series
Light Duty Trip Edge Poly Plow

7 Gauge steel moldboard.

Light weight design.

Tension trip moldboard design using six (6) 3/8” steel wire tension springs with adjusters.

1/4” Thick rib plates.

1/2” x 8” C-1085 Steel blade standard.

3” x 3” x 3/8” Steel backer angle.

Two rebound bumpers to cushion the moldboard when returning to plowing position after tripping action.

Hydraulic reverse capable of 32° of angling.

Locking pin to set moldboard at 3 different locations.

The plow pins on at 30-1/2” centers.

36” High, 10 gauge break formed moldboard curl.

15 degree blade attack angle with heavy duty trip edge design.

Moldboard reverses 35 degrees either side of bull dose position.

Hydraulic ram or manual reverse pushframes available.

Two point level lift chain arrangement standard.

Four 3/4” diameter wire by 13” long torsion spring trip edge return system.

Heavy duty backer angle punched to accept 8” and 12” centers cutting edges.

1/2” by 8” C-1085 reversible cutting edge.

Heavy duty pushframe spanning three attachment points to the moldboard.

Oscillator bar with 3/4” flame cut ears on 31” centers.

Optional carbide blade and moldboard shoes.

Optional mushroom shoe or 10” wheel caster assemblies

Reversible moldboard 35 degrees either side of bull doze poistion.

Trip edge design plow.

3-1/2” Bore x 16” stroke reverse cylinders.

3/8” Polymer UHMW skinplate.

Curb shoes.

31” drive ear centers.

1/2” by 8” Blade on 8” and 12” centers punch pattern.

39” or 45” high moldboard curl.

Optional carbide cutting edge.

Ram reverse or worm gear reverse kits.

Optional adjustable 10” wheel or mushroom shoe caster assemblies.

Trip moldboard design.

Nominal 36” high moldboard tapering from the center line of the moldboard to 54” high at the discharge.

Moldboard capable of reversing 35 degrees either side of the bull dose position.

Two 3-1/2” diameter bore by 16” stroke nitrided reversing cylinders.

2 point level lift chain arrangement or roller level lift arrangement available.

10 gauge break formed skinplate.

Moldboard and curb shoes supplied standard.

31” Oscillator drive ear centers.

1/2” x 8” C-1085 Cutting edge.

Cutting edge backer angle punched on 8” or 12” centers.

Optional carbide cutting edge and carbide moldboard shoes.

Optional adjustable mushroom shoes or 10” Steel wheel caster assemblies.