ACPEA Wing
Single Arm Patrol Wing
Our low profile ACPEA patrol rear module minimizes the mounting area required behind the truck cab for installation.
The ACPEA rear module incorporates a hydraulic cylinder to raise and lower the rear of the wing moldboard.
The wing arm mounting structure is designed to be removable through a pull pin device.
The rear assembly incorporates a base basket to reduce the amount of space requested to mount a sander application or standard dump box.
Our ACP48 front tower is independently controlled providing 48” of vertical wing lift. This system incorporates our 30 degree rubber timbren safety trip dee for full moldboard trip action.
The tower's slider assembly runs full length of the front tower and allows for 6” of wing float.
The tower bolts to the front hitch support cross tubes.
The modular tower attachment brackets provide simple removal to allow for service or off-season weight savings.
If the truck is fitted out with a Power Tilt hitch, this tower will tilt forward with the hitch for ease of truck servicing.
This wing system is also available with our ACP36 fully hydraulic front tower.
Our ACPEA Patrol Hydraulic Telescopic Single Wing Arm Wing system is modular for easy installation and removal.
The ACPEA Patrol Wing System is designed for severe duty applications.
The ACPEA is designed with a single telescopic wing arm with a compression spring shock absorber built in. The wing arm has a cylinder mount to the side to allow the wing arm to extend outwards by 21" to increase the cleared path as needed.
This design also allows for limited shelving capabilities. |
